How To Open Blink Camera

How to Remove the Back Cover of Blink Indoor and Outdoor Cameras

For Outdoor and Indoor (gen two) cameras, the batteries and Device Serial Number (DSN) sticker are found within the dorsum cover. The serial number is needed to add a device to a organization. For automated convenience, we accept added a QR code version of the series number to scan with the Blink mobile app.

Before trying to remove the back comprehend, you must remove the camera from any mounts or accessories. This includes any third-party products.

Your camera shipped with a silicone disc covering the spiral that secures the back cover.

The screw slot allows y'all to utilize the included opening tool/mount adapter unscrew the camera dorsum. You tin can also use a coin, or flathead screwdriver.

A plastic sticker on the dorsum of the camera shows the direction to plough. Turn left (counter clockwise) to open, and right (clockwise) to close.

Remove the picture show earlier photographic camera use.

To remove the back encompass and open the photographic camera

ane. If it is present, remove the silicone protective cover from the fastening spiral, and keep it for future utilise.

2. Employ the included opening tool, to plough the screw counter-clockwise (turning to the left) until the screw spins freely.

3. Apply side force per unit area on the opening tool to gently pry the cover loose. As shown in the analogy, be conscientious to agree the camera on its side, to allow the embrace to come up off.

3.a. (Accessibility) Another way to remove the back cover after it is unscrewed completely, is to plough the opening tool around and insert the mounting finish into the camera's back encompass. So, if you pull the opening tool gently, the camera'due south back embrace comes off because the two are at present attached.

To secure the back cover and close the camera

1. Marshal the guide notches every bit shown, and gently concord the cover in place against the camera torso.

2. Plough the screw clockwise (turning to the right) approximately three turns, or until snug. Accept care to forestall over-tightening. The cover should be affluent with the camera body when you are done.